Fits G1 and G2 .25 Gauntlets 35 shots
The Lid swings off to open. No tools required to reload. Easy reload.
A completely unique and revolutionary design. With over 45 minutes of total machine time per magazine and using top grade Delrin and polycarbonate materials AE Swede has developed a completely unique, high quality and high capacity magazine that fits under just about any scope mount. the profile under the scope is smaller than the stock Avenger magazine and has enough clearance on the side to clear 34mm scopes. If the stock magazine fits your current configuration, so will the SideWinder.
The SideWinder uses 3 pellets for fillers as gear intermeshing components. No worries as these are not permanent and can be used for the next reloading with new filler pellets for those spots.
Never wind up and release the carousel to snap back to it's stop on the SideWinder. The carousel stopper feature is also part of the pellet transfer feature and should not be damaged.
Lift Lid away from lower half of the magazine and swing the lid down and off of the magazine. The top right screw acts as the pivot point. Move the lid away from the pivot point and the lid is free.
Load the small carousel until the pellets meet the large carousel, Wind the large carousel around until it stops and place a pellet in where the small carousel and large carousel meet and intermesh will pellets. This will stop the large carousel from spinning back and it can the be loaded until full. Never partially load the large carousel. Always fully load it.
.25 = 29 shots developed using 25.39 and 33.95 JSB pellets
.22 = 35 shots developed using 15.89, 18, and 25.39 JSB pellets
.177 = 44 shots developed using 10 - 16 grain JSB pellets and slugs
I will support all of my magazine with spare parts. If you ever need a part or parts for your magazine, they can be ordered.